All Questions

Tagged with
Filter by
Sorted by
Tagged with
1
vote
1answer
46 views

Is a RC snubber required when using the pi with a relay?

I am hoping to use raspberry pi to switch on and off a heating lamp and an aquarium pump via a relay switch. Both devices are plugged into 120V AC normally. The relay tutorials online seem to be ...
0
votes
1answer
43 views

Can it damage my Pi to permanently pull down the RUN pin?

I have a use-case where I would leave my Raspberry Pi powered up but keep it in the halted state by pulling down the RUN pinout. Is this safe to do? Edit: The answer shows me that I did not state my ...
2
votes
2answers
154 views

Is it safe to drive a current between a GPIO output at 0V (LOW) and the 3.3V supply?

Normally I would drive a current between a GPIO output at 3.3V (HIGH) and GND, for example to light a LED (with a resistor included of course). I am now wondering if it is safe to drive the current in ...