Questions tagged [hifiberry]

HiFiBerry produce audio add-on boards for the Pi.

10 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
3
votes
0answers
32 views

Microphone is not recording with HifiBerry and Raspberry Pi 3

I installed the HifiBerry driver as specified. The Board is recognized and the audio output works fine. Just the audio input seems to be not working. I checked if the microphone is muted but I can't ...
2
votes
0answers
770 views

Pluging an Adafruit touchscreen on a HifiBerry DAC+

I'm trying to connect a Adafruit PiTFT 2.8" TFT 320x240+ touchscreen and a HifiBerry DAC+ on a Raspberry Pi 2 B. Is it possible? Do I need to solder the touchscreen card on the DAC+?
1
vote
0answers
19 views

FM Radio with HifiBerry Amp2

Is there a way of running a Raspberry Pi 3 with a mounted HifiBerry Amp2 together with an FM Radio Module e.g. TEA5767 FM Radio Breakout Board? Currently I set up my RPI to run Mopidy and Spotify ...
1
vote
1answer
252 views

Connecting Hifiberry Digi+ clone (PiFi Digi+ V1.0) to an Raspberry Pi 1 B (26Pin Header)

Hi I wanted to make use of an older Raspberry Pi and build an Volumio Music Player. I ordered Hifiberry Digi+ clone (PiFi Digi+ V1.0), unfortunately I forgot I own an older Raspberry Pi 1 B with the ...
1
vote
0answers
143 views

conflict GPIO pin (between setting a pull-up resistor and a hat not claiming to use that pin)

I have a raspberry PI 3 (Raspbian) with HifiBerryDac+, running Mixxx. I wanted to run a pythonscript (2.7) which would allow users to automatically restart Mixxx by pressing a button (in case they ...
1
vote
1answer
354 views

Is it possible to use alsamixer eq with shairport-sync hifiberry amp2?

I had shairport-sync functioning with a hifiberry amp2 butwhic the room it was intended for causes the setup to need some eq in a bad way. I followed instructions I found at GitHub, but now I get no ...
1
vote
0answers
112 views

can't launch two device at the same time (hifiberry dac and mcp3008)

kernel version uname -r 4.1.6+ board type gpio -v gpio version: 2.26 Copyright (c) 2012-2015 Gordon Henderson This is free software with ABSOLUTELY NO WARRANTY. For details type: gpio -warranty ...
0
votes
0answers
7 views

Raspberry Pi 3B running Moode skips songs before they end on Tidal

I can't figure out what's happening here : My setup : I use Moode Audio 5.2 as the server and created an OpenHome renderer with the help of BubbleUPnP on my Mac to stream Tidal. I control everything ...
0
votes
0answers
31 views

How to stream audio samples to a DAC - exclusively & low latency

I have an audio add-on card to my Raspi Zero called "raspiaudio", it seems to be reporting as hifiberry, although it is not. It's some NXP DAC conencted via I²C, and the driver was apparently in the ...
0
votes
1answer
109 views

How to connect 2 boards to a raspberry pi 3

I am building a home console stereo and I am going to use an RPi3 with a hifiberry dac+. And I am wondering if I can use a waveshare power relay to be able to control the power to the system from my ...