Stack Exchange Network

Stack Exchange network consists of 174 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers.

Visit Stack Exchange

Questions tagged [pi-3]

For questions that apply specifically to the Raspberry Pi 3 and not other/all models.

0
votes
2answers
605 views

Raspberry Pi Sense HAT on Rpi 3?

I have a question to ask you guys. Can I use the Raspberry Pi Sense HAT (the one used in Astro Pi) with the Raspberry Pi 3 without having any kind of problems? Thanks in advance!
5
votes
1answer
243 views

Can I use my raspberry pi 2 OS for raspberry pi 3 directly?

I recently got hold of the Raspberry Pi 3, and wonder if I safely can use the same SD card loaded with Raspbian that I currently use for my Raspberry Pi 2 on the RP3 as well. The reason for wanting ...
3
votes
2answers
6k views

Raspberry Pi3 Bluetooth

I just got my Raspberry Pi3 and installed Bluetooth sudo service bluetooth status shows ● bluetooth.service - Bluetooth service Loaded: loaded (/lib/systemd/system/bluetooth.service; enabled) ...
0
votes
1answer
292 views

Windows 10 Core IoT Insider Preview 10.0.14279.1000 Bluetooth support

I just installed Windows 10 Core IoT Insider Preview 10.0.14279.1000 on a Raspberry PI 3 and I'm a bit disappointed to see that there is no support for the on-board Wifi or Bluetooth... Later, I read ...
3
votes
1answer
3k views

Raspberry Pi 3 Polyfuse rating?

Does anybody know the model used. Or have done tests to determine at what current load the polyfuse starts kicking in? I want to work out how much current I can draw via the GPIO power pins.
3
votes
1answer
5k views

Pi 3 Boot with UART console

I use Raspberry Pi 3 with image "RASPBIAN JESSIE" which is 2016-02-26 build. I plug in micro-usb to power on. Then I use USB to TTL adapter to try to login. I've set baud rate 115200, and connect GND, ...
1
vote
1answer
102 views

Drawing 0.6A from one usb port on Pi3?

I just got my Raspberry Pi 3 and I am not sure whether or not I can draw 0.6A from ONE USB port (others unused (keyboard and mouse excluded)). Can the RPI handle this? Can I use all slots at once for ...
19
votes
3answers
25k views

Do I need to use a heat sink?

I ordered a Pi 3 and accessory kit here from Amazon, it comes with 2 heat sinks. I won't be overclocking the Pi, would I still need to worry about heat issues? Eventually, this will be in an enclosed ...
3
votes
2answers
10k views

How do I change runlevel on model 3

I want to avoid starting up in GUI mode. I used to edit /etc/inittab but this does not existing anymore.
0
votes
1answer
185 views

SSH hung after entering password just when using wlan and disconect eth0

I have both eth0 and wlan0 actives, can ping both, can run RDP to both IPs (192.168.0.101 for eth0, 192.168.0.102 for wlan0). Ssh to eth0 works OK, ssh to wlan0 works OK as long as I have eth0 ...
77
votes
10answers
222k views

Disable WiFi (wlan0) on Pi 3

Got a Pi 3 which will always use ethernet, so trying to figure out how to disable the WiFi such that it does not even turn on after a reboot. If I do an ifconfig I see the wlan0 device. I can do ...
2
votes
0answers
1k views

Does RPi 3 have the same bandwidth for ethernet and USB?

It seems that's the case for the last Pi. But does the new one also have this limitation? Not duplicate, but reffered question:    USB bandwidth for the RPi model B+   &...
0
votes
2answers
7k views

Wi-Fi Setup Raspberry Pi 3 with WPS (Wi-Fi Protected Setup) not working

I'm using wpa_supplicant with wpa_cli and manually entering SSID and passphrase to connect to network works without problems. When using wpa_cli with command wps_pbc it sees the WPS enabled access ...
-3
votes
1answer
996 views

How well can you run OS X on a Raspberry Pi 3?

I am thinking about buying a Raspberry Pi 3 just to run OS X 10.11. How well will it work based on the Mac specs vs. Pi 3 specs?
3
votes
1answer
1k views

Running multiple servers at the same time

I have recently discovered the Raspberry Pi, and I have a question. I did not find any answer. Can I configure one Raspberry Pi 2 B or 3 B to run 2 servers at the same time (for example a web server ...
10
votes
4answers
12k views

Can I Install Debian 64 bit on RPi 3

The Raspberry Pi 3 is built with a 64 bit chip. Yet the Raspberry Pi Foundation has only released Linux distros are 32 bit. Can I install a 64-bit version of Debian on the RPi 3?
7
votes
2answers
96k views

Raspberry Pi 3 - internal Wifi wont connect to network

i'm rather new to Linux and all that, in fact the Raspberry Pi 3 i just got is the first Linux-only machine i ever had, running the latest version of Raspbian .. so here's my problem: I'm trying to ...
13
votes
3answers
9k views

Maximum current on each GPIO pin for Raspberry Pi 3 Model B

Anyone knows what's the maximum input/output current for the individual GPIO pins? Perfectly fine if someone is able to point me to the Broadcom BCM2837 datasheet, which I for some reason, cannot ...
11
votes
4answers
20k views

Raspberry 3 - Boot From USB - but how?

Apparently the Raspberry Pi 3 can boot from things other than the SD Card, including USB flash drives. I got my Pi 3 today (hurray!) and burnt the latest Raspbian to both an SD card and a USB flash ...
5
votes
1answer
11k views

Pi3 wireless drivers

I am using Archlinux ARM for raspberry pi 3 (Which is identical, for now, to the pi2 image). I can't get the on board WiFi to work. in lsmod I do see "cfg80211" is loaded, but the interface I see are ...
6
votes
2answers
2k views

Raspberry Pi 3 usable with fully free software?

In the Free Software Foundation's May 2013 review of single board computers, the Raspberry Pi was found to have fatal flaws for use in a free (libre) software environment: The Raspberry Pi requires ...
14
votes
6answers
27k views

How to enable Wi-Fi channel 12 on Raspberry Pi 3?

I need my RPi 3 to connect to a Wi-Fi network using channel 12, but I'm not able to get the built-in Wi-Fi adapter to use this channel. This is what I've done: $ sudo apt-get install wireless-regdb ...
7
votes
3answers
20k views

Does the BCM43438 WiFi chip in Raspberry Pi 3 support power management setting?

I'm trying to disable the wireless power save on my RPI3, but can't do it: $ sudo iwconfig wlan0 power off Error for wireless request "Set Power Management" (8B2C): SET failed on device wlan0 ; ...
1
vote
1answer
65 views

Create a boot disk which can be SSH-ed into via WiFi

I've got a new pi 3. I haven't got a spare monitor or keyboard, so I was wondering... Is it possible to create an SD card bootable OS (noobs, raspian, ubuntu etc) which can be connected using wifi ...
5
votes
1answer
1k views

What is the Limit of the Broadcom Architecture? [closed]

When I read the spec sheet for the Raspberry Pi 3, I was both excited and slightly disappointed. Excited because the Raspberry Pi Foundation continues to release Raspberry Pis with ever increasing CPU ...
1
vote
1answer
612 views

Performance of the Raspberry Pi 3

The Raspberry Pi 3 is quoted as having a 33% increase in clock speed over the Raspberry Pi 2. But what does this mean for real world performance? For example the Raspberry Pi 2 I have runs OpenELEC ...
1
vote
1answer
5k views

OpenELEC for Raspberry Pi 3

Will there be a new version of OpenELEC for the Raspberry Pi 3? Or would the install file for the Raspberry Pi 2 work?
5
votes
3answers
12k views

Raspberry Pi 3 Web Browsing

New to RPi but I'm seeing a lot of stuff about how it has struggled in the past to web browse -- particularly on heavy-js sites and with video and such. Is this a problem of the past? Especially now ...
24
votes
4answers
90k views

Raspberry Pi 3 audio input?

Did Raspberry Pi 3 add audio input? I'm new to RPi and interested in doing speech recognition but noticed input has been missing for previous versions. If it hasn't, what is the best way for me to go ...
3
votes
1answer
9k views

Will Tails OS work on Raspberry Pi 3?

The System Requirements page for Tails states that Tails requires: 2 GB of RAM to work smoothly. Tails is known to work with less memory but you might experience strange behaviours or crashes. ...
37
votes
4answers
84k views

Add an external antenna to a Pi 3

Makezine's writeup on the Pi 3 this morning included a somewhat tantalising section: The other interesting thing on the back of the board, right next to the wireless radio chip, is something that ...
34
votes
7answers
81k views

Does Pi3 Wi-Fi support 5 GHz and does it need an extra antenna?

I was wondering if the built-in Wi-Fi supports 5 GHz networks? Will it need an external antenna to be attached to work properly?
12
votes
6answers
28k views

Raspberry Pi Model B 3 Overclocking?

With the release of the Raspberry Pi Model B 3 today, I'm sure we're all very excited to see the speed of this new Pi. The standard clock is 1.2Ghz, but I'd like to push mine further. I know the Pi 3 ...
3
votes
3answers
1k views

Air-gapping the Raspberry Pi 3

One thing I love about my Raspberry Pi 2 is that I can use them as tiny air-gapped devices (I know I could use the Zero too: but they're not as powerful and kinda hard to find). I'm using one to run ...
47
votes
2answers
109k views

Raspberry Pi 3 vs Pi 2 power consumption and heat dissipation

I've seen the announcement of the new Raspberry 3 but didn't find any info regarding power consumption and heating. A 1.2 Ghz 64-bit CPU is great but does it draw a lot more power? Shall heat be an ...
10
votes
3answers
7k views

Windows 10 IoT / Raspberry Pi 3

Does anyone have any links to information on the planned support / roadmap for Windows 10 IoT on Raspberry Pi3? In particular; 64 bit support Wifi / Blue tooth drivers
4
votes
2answers
5k views

Virtualization on Pi 3 Raspbian

The new Pi 3 was announced this morning. It's the first Pi to ship with a 64-bit processor, the ARM Cortex A53. The product page for that chip suggests that it's capable of hardware virtualization. ...
14
votes
3answers
5k views

What are the differences between the Model 2B and 3B?

Having seen an official part/order number (SC14012 or SC14014 with 16GB micro SD Noobs software) including what looks to be a real photographic image in a recent (2016/02/27 "Computer World" March ...
9
votes
6answers
20k views

Raspberry Pi connected to internet but can't SSH or Ping

I have a Raspberry Pi Model 2 running the newest version of Raspbian Jessie. My Pi is connected to the internet using an Edimax Wireless adapter, and I can download and browse the internet just fine. ...
5
votes
7answers
6k views

Setting up PBX using Asterisk and Free PBX, with skype, PSTN (Talk Talk UK), and gsm gateway in the future

I am thinking of setting up a PBX at home. I am reasonably tech savvy but have never set up a PBX before. There seems to be a lot of info out there but I was wondering if someone could: Sense check ...