Questions tagged [pi-3]

For questions that apply specifically to the Raspberry Pi 3 and not other/all models.

Filter by
Sorted by
Tagged with
1
vote
1answer
2k views

Unable to link Bluetooth keyboard to Pi 3

I have enabled Bluetooth on my Pi 3 and connected phone and laptop successfully. When I try to connect my Apple or Logitech keyboard it says failed to connect on pairing. I've tried via terminal and ...
1
vote
1answer
2k views

No signal from MCP3008 to RPi 3 using Python

I connected a Raspberry Pi 3 with ArchLinux to a MCP3008 following the wiring explained in this tutorial. When I run lsmod I see spi_bcm2835. My /boot/config.txt has the following line to enable spi:...
1
vote
0answers
791 views

Pi3 Lirc problem

I had my Raspberry Pi 2 setup with lirc, fully working with the keys that I needed. But when i upgraded to Pi 3, using the same GPIO pins, configuration and remote control, I can`t get irrecord to ...
1
vote
2answers
178 views

Long distance use of an RPi 3 B

I have recently acquired an RPi 3 model B. Because I do a lot of traveling I have several questions about the safety and ability of leaving a RPi active while being far away. I am not mainly concerned ...
5
votes
1answer
16k views

No display output from Raspberry Pi 3

The Pi is connected to the power supply (5V 2000mA) and the HDMI is connected to monitor (1600 x 900). The status of my Pi is as follows: Red light is solid Green light blinks randomly Ethernet port ...
0
votes
1answer
434 views

Upgraded from Pi2 to Pi3 - Internal wireless adapter isn't working

I've bought my new Raspberry Pi 3, plugged it in, took my Raspberry Pi 2 SD Card with Raspbian installed on it. Turned it on, everything is working great and faster than ever - but! No wireless ...
1
vote
0answers
453 views

Bridging wlan0 and eth0 with pi 3 on Raspbian Jessie [duplicate]

I am trying to bridge wlan0 and eth0 on my pi 3 running the latest Raspbian "Jessie". I am running into 2 issues when trying to set this up. when trying to use command sudo brctl addif bro wlan0 ...
26
votes
1answer
6k views

Why can't the Pi 3 receive FM radio by itself?

I've read online that the Pi 3's WiFi/Bluetooth chip (BCM43438) can also receive FM radio. Why can't I use it to receive FM signals?
1
vote
0answers
147 views

Raspberry Pi 3 Cannot Find SD Card After First Boot

I'm a newbie when dealing with the Pi, as this is my first project with one. I installed the latest version of Retropie on a 32 GB Samsung Micro SD card. The initial boot works as expected; the ...
3
votes
0answers
500 views

Windows IoT RPi3 Install Error

I am unable to install Windows IoT on my RPi3. I have signed up for insider and can start the download of the windows image but after it has downloaded about 500mb it fails with the message: "windows ...
0
votes
2answers
4k views

Can a Raspberry Pi handle 2 external HDDs and a keyboard/mouse?

I just got the CanaKit Raspberry Pi 3 starter kit, and I was wondering if it can handle all of the following via its USB ports: BlackArmor WS 110 2TB Seagate FreeAgent Desk 1 TB (Wireless) Keyboard ...
8
votes
2answers
2k views

Raspberry Pi 3 usable with fully free software?

In the Free Software Foundation's May 2013 review of single board computers, the Raspberry Pi was found to have fatal flaws for use in a free (libre) software environment: The Raspberry Pi requires ...
3
votes
2answers
7k views

Raspberry Pi3 Bluetooth

I just got my Raspberry Pi3 and installed Bluetooth sudo service bluetooth status shows ● bluetooth.service - Bluetooth service Loaded: loaded (/lib/systemd/system/bluetooth.service; enabled) ...
4
votes
1answer
351 views

Can I use my raspberry pi 2 OS for raspberry pi 3 directly?

I recently got hold of the Raspberry Pi 3, and wonder if I safely can use the same SD card loaded with Raspbian that I currently use for my Raspberry Pi 2 on the RP3 as well. The reason for wanting ...
3
votes
1answer
6k views

Pi 3 Boot with UART console

I use Raspberry Pi 3 with image "RASPBIAN JESSIE" which is 2016-02-26 build. I plug in micro-usb to power on. Then I use USB to TTL adapter to try to login. I've set baud rate 115200, and connect GND, ...
10
votes
3answers
7k views

Windows 10 IoT / Raspberry Pi 3

Does anyone have any links to information on the planned support / roadmap for Windows 10 IoT on Raspberry Pi3? In particular; 64 bit support Wifi / Blue tooth drivers
1
vote
1answer
110 views

Drawing 0.6A from one usb port on Pi3?

I just got my Raspberry Pi 3 and I am not sure whether or not I can draw 0.6A from ONE USB port (others unused (keyboard and mouse excluded)). Can the RPI handle this? Can I use all slots at once for ...
2
votes
0answers
1k views

Does RPi 3 have the same bandwidth for ethernet and USB?

It seems that's the case for the last Pi. But does the new one also have this limitation? Not duplicate, but reffered question:    USB bandwidth for the RPi model B+   &...
-3
votes
1answer
1k views

How well can you run OS X on a Raspberry Pi 3?

I am thinking about buying a Raspberry Pi 3 just to run OS X 10.11. How well will it work based on the Mac specs vs. Pi 3 specs?
2
votes
1answer
2k views

Running multiple servers at the same time

I have recently discovered the Raspberry Pi, and I have a question. I did not find any answer. Can I configure one Raspberry Pi 2 B or 3 B to run 2 servers at the same time (for example a web server ...
1
vote
1answer
70 views

Create a boot disk which can be SSH-ed into via WiFi

I've got a new pi 3. I haven't got a spare monitor or keyboard, so I was wondering... Is it possible to create an SD card bootable OS (noobs, raspian, ubuntu etc) which can be connected using wifi ...
1
vote
1answer
628 views

Performance of the Raspberry Pi 3

The Raspberry Pi 3 is quoted as having a 33% increase in clock speed over the Raspberry Pi 2. But what does this mean for real world performance? For example the Raspberry Pi 2 I have runs OpenELEC ...
1
vote
1answer
5k views

OpenELEC for Raspberry Pi 3

Will there be a new version of OpenELEC for the Raspberry Pi 3? Or would the install file for the Raspberry Pi 2 work?

1
64 65 66 67
68