Skip to main content

All Questions

Filter by
Sorted by
Tagged with
36 votes
9 answers
135k views

Will any external battery power a Raspberry Pi?

I am working on a project that needs the Raspberry Pi to work without a mains connection. I have considered buying a 50000mAh USB power bank. Would this power a Raspberry Pi, and if so, would it ...
-1 votes
2 answers
85 views

Powering Raspberry Pi 5B with li-ion battries: Pi 5 just won't boot, stops booting mid-way

I've been pulling my hair for a couple of weeks now. Changed batteries, changed BMS, changed step-down module. No avail. I am trying to run RPi 5B with 4 li-ion cells in 2S2P config. 2S2P -> BMS -&...
4 votes
1 answer
2k views

Power with batteries on 3.3V

I've already investigated how to power the RPi with batteries (I did some tests with AA batteries and with 18650 batteries) using a 5V "boost" step-up DC-DC converter, in some other questions here. ...
4 votes
5 answers
17k views

Will a Duracell 9V battery power my Raspberry Pi for 24 hours? [duplicate]

Will a Duracell 9V battery power my Raspberry Pi (plus camera module) for 24 hours? I've tried power banks and the 50,000mAh rating seems a bit exaggerated, considering I'm getting just 5/6 hours ...
-1 votes
1 answer
406 views

How to turn on a remote battery-operated Raspberry Pi (accessible by Wifi or SSH)?

I am running a cluster of Pi3 and Pi4. Each node runs on a battery and is powered by a solar panel, in a remote area like a farm with no grid. Pis are connected to each other by WiFi in a local ...
0 votes
0 answers
18 views

Powering a Pi 4 with a small power bank [duplicate]

For my project SamplerBox, I had done many extensive tests in the past and it was possible to successfully power a RPi 2 for multiple hours with such a small 2600mAh power bank (18650-battery inside), ...
0 votes
0 answers
43 views

Turning switch on lowers voltage from 5.2v to 3.0v

This is probably a simple question, but I’ve researched a lot and haven’t been able to figure out how to fix the problem. Basically, I have a Raspberry Pi and a 5-inch LCD screen wired to a toggle ...
2 votes
0 answers
1k views

how to power a raspberry pi zero w, with a 2x18650 bay, through GPIO

I'd like to wire this bay to the GPIOs of a rpi zero w. The bay welcomes 2S 2x18,650. On each cell is written "9800mAh TR 18650 3.7v Li-ion". My requirements are : One micro-USB port must ...
3 votes
1 answer
944 views

Battery Usage Pi Zero W for video stream

I am trying to do live video streaming from the rasberry pi, meaning the camera is recording a video and then transmitting the live video over wifi. What is the smallest battery I can use to power ...
2 votes
2 answers
10k views

Car Powered Raspberry Pi: Safe Shutdown and Power On

Apologies if this is a duplicate, but I can't seem to find a suitable solution. I need to power a Raspberry Pi in a car, and for obvious reasons need to shutdown gracefully, however, I need it to ...
0 votes
2 answers
1k views

Is it safe to use this battery with the Raspberry Pi Zero?

I have two questions actually: 1) is it safe to use this battery and these wires with the raspberry pi zero? 2) if yes, where do i solder the highlighted (red square) ends to the zero board?
4 votes
4 answers
6k views

Battery pack for model B RPI, Thoughts?

Thinking of getting the battery pack linked to below for my model b Raspberry pi, i am wondering if anyone knows anything about it and how could it is because for first glance it looks amazing. Thanks ...
9 votes
5 answers
2k views

UPS for raspberry pi

I want to be able to power my pi like a smartphone (ie from battery or from mains (while charging the battery), hot swappable) I know there are boards like the MoPi that achieve this, but the ...
0 votes
4 answers
3k views

7.2V battery with Raspberry Pi

I want to use a 7.2V (4200mAh) battery with my raspberry pi but I need to convert the output to 5V (2000mAh), I tried the following formula: Ω = V / A but when I try to find the ohms the result is ...
0 votes
0 answers
30 views

How does a Raspberry Pi 3 react with low voltage as batteries die? [duplicate]

How does the Raspberry pi react as voltage drops from batteries die? Does it eventually automatically halt or do I need to worry about unpredictable side effects from running the batteries dead?
0 votes
1 answer
1k views

How can I display the charge from a battery on my Pi? [closed]

I have a robot that uses a Raspberry Pi 3 Model B and a 12 volt sealed lead acid battery. The battery powers other things (motors, etc), and the Pi receives a regulated current. How can I display the ...
2 votes
3 answers
3k views

Can This UPS(UNINTERRUPTIBLE POWER SUPPLY) Run a Raspberry Pi for 24hours?

I am setting up an experiment that will need to run for 15 days straight and I am using a Raspberry Pi as a data logger. In my place power outages occurs from time to time. I am searching for cheap ...
2 votes
2 answers
1k views

Portable power supply for a PiHub?

I love my PiHUB and would like to have a or table power source, so I can make my projects mobile :) Is there any product that I could use? It uses 3A 5.2V. Alternatively I'd appreciate any ...