All Questions

Tagged with
Filter by
Sorted by
Tagged with
1
vote
1answer
2k views

Cloning RFID tags with Raspberry Pi 3 and RC522?

I've looked around a lot now and can barely find any information on how to clone RFID tags with the Raspberry Pi, I've seen plenty of content on how to do it using an Arduino but I would really rather ...
1
vote
1answer
274 views

Parallax RFID Serial Not reading tags

I am a complete newbie with Raspberry Pi and any type of hardware prototyping. I have been trying to get a Parallax RFID working with my Pi 3. I currently have it wired to the GPIO using BCM and the ...
5
votes
2answers
2k views

Impossible to scan RFID tags using libnfc, PN532, and RPi3

I recently bought this NFC/RFID reader PN532 module V3 I want to use it with my raspberry pi 3. I have install and configured the library libnfc. The PN532 is connected with I2C. I have well enabled ...
1
vote
0answers
570 views

Raspberry Pi Zero 433mhz transmitter fails but works on raspberry Pi 2

So I am using some 433mhz modules. I had them setup on my raspberry Pi2 and everything worked perfect. They could transmit and receive signals. I switched the entire configuration over to a raspberry ...
1
vote
0answers
996 views

How to connect Multiple RFID Readers to a Single Raspberry Pi [duplicate]

I would like to interface multiple RFID Readers to a single Raspberry Pi. Any option can be chosen either wired or wirelessly.
1
vote
2answers
3k views

MFRC522 Not working over SPI Interface

I am running (on a Pi3) an MFRRC522 reader - much like this one: It has been working fine, but after I changed SD card, to increase capacity - whilst also doing a new Raspian install I haven't been ...
1
vote
2answers
9k views

ITEAD PN532 on Pi 3 with libnfc

For the past weeks I have been trying to get the ITEAD PN532 NFC board working on a Raspberry Pi 3 running Raspbian Jessie (2016-03-18) using libnfc. Here's some info on the board itself. It has two ...
4
votes
1answer
8k views

Major trouble with nRF24L01+ controllers and the RF24 library

I've had a hellish last three days. All I've wanted to do is get an Arduino Uno and a Raspberry Pi B+ talking to eachother with these little guys, and after following many different tutorials, I've ...
1
vote
1answer
658 views

Is there any generic cheap RF module [duplicate]

Recently I got cheap RF remote controlled plug points. I hacked the remote to control buttons using raspberry pi and it works great. My question is, is there any generic RF transmitter and receiver ...