Skip to main content

All Questions

Tagged with
Filter by
Sorted by
Tagged with
0 votes
1 answer
140 views

AS5600 encoder is not reading on Raspberry Pi 4

I'm trying to read the stepper motor angle using the AS5600 magnetic position encoder. I'm using Raspberry Pi 4 and the pinout is the following: VCC to 3.3V , GND to Ground ,SDA to GPIO2 (Pin 3) , SCL ...
0 votes
0 answers
219 views

HC-SR04 Ultrasonic Sensor Heating Up and Not Working

I have two breadboards (for the front and back of a go-kart) which are supplied by the 5V power pins of the raspberry pi 4 respectively (pins 2 and 4). However, when both are plugged in, the second ...