All Questions
2 questions
0
votes
1
answer
140
views
AS5600 encoder is not reading on Raspberry Pi 4
I'm trying to read the stepper motor angle using the AS5600 magnetic position encoder.
I'm using Raspberry Pi 4 and the pinout is the following:
VCC to 3.3V , GND to Ground ,SDA to GPIO2 (Pin 3) , SCL ...
- 1
0
votes
0
answers
219
views
HC-SR04 Ultrasonic Sensor Heating Up and Not Working
I have two breadboards (for the front and back of a go-kart) which are supplied by the 5V power pins of the raspberry pi 4 respectively (pins 2 and 4). However, when both are plugged in, the second ...
