My raspberry pi runs ArchLinux and since I enabled IPv6 in our local router config, the pi only fires up an IPv6 connection in LAN. But I have trouble to find out the address.

Once I connected a display and found out the address is `fe80::ba27:ebff:fe4a:6a12`. I was able to connect to the pi with the folling command:

    ssh -6 user@fe80::ba27:ebff:fe4a:6a12%wlp3s0

Where `wlp3s0` is the wifi device of my local client.

For IPv4 [I use nmap][1], but I have trouble to translate that command to work with a local IPv6 network. I understand nmap also offers an `--ipv6` or `-6` flag, but what is the correct subnet string? And, does that even work? Is that even possible?

Here is my client's `ip a` output:

     user@computer ~ $ ip a
    1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1
        link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
        inet 127.0.0.1/8 scope host lo
           valid_lft forever preferred_lft forever
        inet6 ::1/128 scope host 
           valid_lft forever preferred_lft forever
    2: eno1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UP group default qlen 1000
        link/ether d4:3d:7e:**:**:** brd ff:ff:ff:ff:ff:ff
        inet 192.168.178.28/24 brd 192.168.178.255 scope global eno1
           valid_lft forever preferred_lft forever
        inet6 2002:5dc4:6c0e:*:****:****:****:****/64 scope global mngtmpaddr noprefixroute dynamic 
           valid_lft 7191sec preferred_lft 3591sec
        inet6 fe80::1543:f119:fbae:743b/64 scope link 
           valid_lft forever preferred_lft forever

Is it even possible to scan an IPv6 network?


  [1]: http://raspberrypi.stackexchange.com/q/13936/13836