Question
I2C device reading writing errors problem. How to solve it?
Answer
There are many reasons causing reading and writing errors. To name a few:
Wires too long (more than 30cm) and not twisted. A suggestion is to use twisted cable Cat 5 to reduce mains EMI noise picking up,
I2C speed too high. A suggestion it to start testing a low speed, such as 100kHz,
Pullup overloading Rpi which already has 1k8 pull up. A suggestion is to remove ALL pullups of the I2C devices,
Rpi I2C circuit too noisy. A suggestion is to use logical level converters such as TXS010n, TXB010n to step up 3V3 signal to 5V (high level means low risk of noise etc problem)
PSU dirty. A suggestion is to place standard bypass/decoupling cpas 10u tantalum and 0.1 ceramic near the device and also near the Rpi mciro USB connector.
/ to continue, ...
References
Clean Power for Every IC, Part 1: Understanding Bypass Capacitors - Robert Keim, AAC 2015sep21
Introduction
It is not inconceivable that a dedicated, successful engineering student would graduate from college knowing almost nothing about one of the most pervasive and important components found in real circuits: the bypass capacitor. Even experienced engineers may not fully understand why they include 0.1 µF ceramic capacitors next to every power pin of every IC in every circuit board they design. This article provides information that will help you to understand why bypass capacitors are necessary and how they improve circuit performance, and a follow-up article will focus on details related to choosing bypass capacitors and the PCB layout techniques that maximize their efficacy.
...
Solution
it is convenient that such a serious problem can be effectively resolved with a simple, widely available component. But why the capacitor? A straightforward explanation is the following: A capacitor stores charge that can be supplied to the IC with very low series resistance and very low series inductance. Thus, transient currents can be supplied from the bypass capacitor (through minimal resistance and inductance) instead of from the power line (through comparatively large resistance and inductance). To better understand this, we need to review some basic concepts related to how a capacitor affects a circuit.
First, though, a brief note about terminology: The components discussed in this article are regularly referred to as both “bypass capacitors” and “decoupling capacitors.” There is a subtle distinction here—“decoupling” refers to reducing the degree to which one part of a circuit influences another, and “bypass” refers to providing a low-impedance path that allows noise to “pass by” an IC on its way to the ground node. Both terms can be correctly used because a bypass/decoupling capacitor accomplishes both tasks. In this article, however, “bypass capacitor” is favored in order to avoid confusion with a series decoupling capacitor used to block the DC component of a signal.
A Standard Approach
The foregoing analysis helps us to understand a classic bypassing scheme:
a 10 µF capacitor within an inch or two of the IC, and
a 0.1 µF ceramic capacitor as close to the power pin as possible:
The larger capacitor smooths out lower-frequency variations in the supply voltage, and the smaller capacitor more effectively filters out high-frequency noise on the power line.
If we incorporate these bypass capacitors into the 8-inverter simulation discussed above, the ringing is eliminated and the magnitude of the voltage disturbance is reduced from 1 mV to 20 µV, ...