# Solution steps to reproduce:

1. be sure you are connected on internet so download and install `Raspberry Pi Imager` from official https://www.raspberrypi.org/software/
2. so from your `macOS` open up `Raspberry Pi Imager`
3. at operating system choose `Erase Format card as FAT32`. So choose `Storage` and then `Write` 
4. at operating system choose `Raspberry Pi OS (other)` then choose `Raspberry Pi OS Lite (32-bit)`. So choose `Storage` and then `Write` 
5. to let `ssh` available into `raspberrypi` just create an empty file called `ssh` into `/Volumes/boot`
6. you can now safely disconnect `/Volumes/boot`
7. power-on via `ethernet` this `raspberrypi` with the new `boot`
8. be sure on your `macOS` file `~/.ssh/config` is empty 
9. be sure on your `macOS` file `~/.ssh/known_hosts` is empty 
10. from your `macOS` open up a terminal and run command `ssh [email protected]` so choose `yes` and type default password `raspberry` 
11. get `ip` of `raspberrypi` by running command `hostname -I` 
12. run command `exit`
13. now use command `ssh pi@<ip address you copied just above>` so choose `yes` and type default password `raspberry`

# Environment 

###### macOS 
```bash
➜  ~ sw_vers        
ProductName:	macOS
ProductVersion:	11.4
BuildVersion:	20F71

➜  ~ /usr/bin/ssh -V
OpenSSH_8.1p1, LibreSSL 2.7.3
```

###### raspberrypi
```bash
pi@raspberrypi:~ $ lsb_release -a
No LSB modules are available.
Distributor ID: Raspbian
Description:    Raspbian GNU/Linux 10 (buster)
Release:    10
Codename:   buster

pi@raspberrypi:~ $ ssh -V
OpenSSH_7.9p1 Raspbian-10+deb10u2+rpt1, OpenSSL 1.1.1d  10 Sep 2019
```