New answers tagged

2

You have many questions and as you see there are many answers. Btw. you cannot bridge a WiFi client connection. It is not supported by the on board WiFi chip. For further information about this issue you can look at Raspberry Pi WiFi to Ethernet Bridge for a server?. If you like to look at handmade solutions for Raspberry Pi you can look for Access Point ...


1

On my schematic here, where your Wireguard VPN server must be ?


2

From debian.org i have tested ProxyArp and DHCP relay with parprouted, dhcp-helper and avahi-daemon packages and it's work for me on Raspbian. My other computer (ethernet connected device) get his dhcp IP addr successfully trought the RPi with full IP connectivity. Detail: I use bcm wlan0 RPi interface for internet wireless gateway (W.A.P on fire) ...


2

⠠⠞⠗⠽ this tutorial: Start with a clean install of the latest release of Raspbian (currently Buster). Raspbian Buster Lite is recommended. Update Raspbian, including the kernel and firmware, followed by a reboot: sudo apt-get update sudo apt-get dist-upgrade sudo reboot Set the WiFi country in raspi-config’s Localisation Options: sudo raspi-config If you ...


1

Try following this tutorial. I have something like this in my house to extend the WiFi coverage. I don't recall if I followed this exact tutorial, but these are the basic steps that I followed. I will paste the major steps from the tutorial here: Step 1: Install and update Raspbian Step 2: Install hostapd and dnsmasq Step 3: Configure a static IP for the ...


1

First of all: you cannot bridge the interface from the built-in wifi device on any Raspberry Pi including RPi 4B if you use it for a client connection (uplink) to a hotspot. This is due to a hardware limitation with WDS and 4addr. For further information look at Raspberry Pi WiFi to Ethernet Bridge for a server?. Fortunately there is a workaround with ...


Top 50 recent answers are included