Peter Green's user avatar
Peter Green's user avatar
Peter Green's user avatar
Peter Green
  • Member for 8 years, 2 months
  • Last seen this week
327 votes
Accepted

What is rpikernelhack?

31 votes
Accepted

Were CPU features removed on the Raspberry Pi 4 revision 1.5 board?

20 votes
Accepted

Will Raspberry Pi OS update `sudo` to address a recent security vulnerability?

15 votes
Accepted

How to install Raspbian without an SD card reader

14 votes

RPI 4 - POE enabled but requires hat?

10 votes

Is the BCM2835 (Broadcom SoC) proprietary to the Raspberry Pi organization?

8 votes

Can the Pi Zero act as an USB peripheral device?

8 votes

Does the Raspberry Pi have Hardware Floating Point support?

8 votes
Accepted

Raspbian migration from Raspberry Pi 2 to Raspberry Pi 3

8 votes

how does the Raspberry Pi PoE shield work?

6 votes

Does the Raspberry Pi 3 support UHS-II microSDHC cards?

6 votes

Is there a component out there that can push a button i.e. will extend a rod about 1 inch and then retract it?

6 votes
Accepted

How to add a package to official raspbian repositories?

5 votes

Is it possible to add RAM to Raspberry Pi?

5 votes

What happened to Raspberry Pi 2- and 3- Model A?

4 votes

What's the difference between UUID and PARTUUID?

4 votes

How to read values from an clamp-on ammeter with an raspberry pi?

4 votes

Impact of using UART

4 votes
Accepted

Why is pull up resistor preferred over pull down for the matrix keypad?

4 votes

Is it possible to use an additional HAT with the Raspberry Pi PoE HAT

4 votes
Accepted

Why is the L2 cache disabled by default on Raspbian Jessie?

4 votes

Can i fit a 2x5 pin crimp connector on the raspberry pi pins?

4 votes

Are there any technical limitations when running hard-float binaries on a soft-float OS?

4 votes

Can't apt-get install libssl-dev

4 votes

Can the USB ports be used to power the Raspberry Pi?

3 votes

OpenVPN Site to Site client on raspbian

3 votes

Can't restore raspberry OS from img created with dd command

3 votes

# symbol not on my keyboard

3 votes

Ethernet port on Zero and A+?

3 votes

What kind of connector do I use for the Pi's GPIO pins?