11chubby11
  • Member for 9 years, 5 months
  • Last seen more than 1 year ago
How to setup multiple WiFi networks?
Accepted answer
122 votes

This post was OK at the time for Wheezy. DO NOT USE Edit /etc/wpa_supplicant/wpa_supplicant.conf and add id_str="school" under the schools wpa info and id_str="home" under your ...

View answer
RasPi Camera Board and Motion
Accepted answer
57 votes

You can access the camera board on /dev/video0 by running the command: sudo modprobe bcm2835-v4l2 This will have to be run on every boot of the device. Or you can put modprobe bcm2835-v4l2 in /etc/...

View answer
Setting camera module to /dev/video0 to scan QR Codes using zbar
4 votes

You can access the camera board on /dev/video0 by running the command: sudo modprobe bcm2835-v4l2 This will have to be run on every boot of the device. Or you can put modprobe bcm2835-v4l2 in /etc/...

View answer
Raspberry Pi has big red R on screen frozen
Accepted answer
3 votes

RaspBMC has a big 'R' while it boots up. Maybe you installed that and not Raspbian like you thought. Here is a picture of the RaspBMC splash screen while it boots: If that's what you're seeing, ...

View answer
Raspbmc CEC with Panasonic TX-P42X50B (Viera link)
Accepted answer
3 votes

I use my Pi with Raspbmc on it with my Viera TV to watch movies. My remote controls the Pi perfectly but Im not using Viera Link at all. I just have my Pi connected to the HDMI port, just as if was a ...

View answer
wpa-roam can only be used with the manual inet method
3 votes

In /etc/network/interfaces Change iface wlan0 inet static to iface wlan0 inet manual Now put in a new line: iface somenamehere inet static Then cut the wlan0 static IP info(not the wpa-roam part) ...

View answer
No network found on new Pi 2 but works fine with B+
2 votes

As user236012 commented, you cannot have the same IP address for two different devices. This setup would only work if you only had one Raspberry Pi connected to the network at a time.

View answer
Raspbmc network configuration file troubles
1 votes

In /etc/network/interfaces change iface wlan0 inet static to iface wlan0 inet manual then cut everything under that except for wpa-conf /etc/wpa.config and paste it under a new line called: iface ...

View answer
PI streaming audio with mplayer runs for a while and then becomes unresponive
1 votes

My Pi used to freeze up and I tracked it back to the 800mhz overclock that they say "most Pi's can handle". I used to get freezes every few hours. Got rid of ALL overclocking settings and got it ...

View answer
Picam noir issue
0 votes

The camera may be running out of GPU memory. Check config.txt in the /boot/ folder. The gpu_mem option should be at least 128. Alternatively, use the Memory Split option in the Advanced section of ...

View answer