Timeline for I Cannot Change the State of the GPIO Pins
Current License: CC BY-SA 3.0
7 events
| when toggle format | what | by | license | comment | |
|---|---|---|---|---|---|
| Nov 25, 2015 at 9:08 | comment | added | joan | @goldilocks Given that gpio readall sees the change I think you are right in assuming there may be a mismatch between the GPIO the OP is using and the GPIO the OP thinks they are using. | |
| Nov 25, 2015 at 4:13 | comment | added | goldilocks♦ | As joan says, the only way someone else can confirm you aren't doing anything wrong is to see all the details. E.g., there are several different numbering systems used to refer to the pins, which can cause confusion, and a diagram or photo is necessary to rule that out. | |
| Nov 25, 2015 at 3:19 | answer | added | SlySven | timeline score: 1 | |
| Nov 24, 2015 at 22:19 | answer | added | Bob Kruse | timeline score: 1 | |
| Nov 24, 2015 at 22:13 | comment | added | joan | I am going to assume the actual question is how do I switch a LED on and off. How have you connected the LED to the Pi? Could you edit your question to include those details (including the LED colour, resistor value used, and GPIO used). A photo will be helpful. | |
| Nov 24, 2015 at 22:12 | review | First posts | |||
| Nov 25, 2015 at 0:29 | |||||
| Nov 24, 2015 at 22:02 | history | asked | Ryan | CC BY-SA 3.0 |