Timeline for Pi works, GPIO part will not cooperate
Current License: CC BY-SA 3.0
10 events
| when toggle format | what | by | license | comment | |
|---|---|---|---|---|---|
| Jan 13, 2015 at 2:57 | comment | added | goldilocks♦ |
You can use the rails on the side of that breakout -> breadboard instead of the individual GND and 3.3V pins. In the pic you've jumped GND to the - half of the rail -- they're the same thing. So harmless, but you should be careful and make sure you are clear on these things because you could break something!
|
|
| Jan 13, 2015 at 1:35 | answer | added | dockeryZ | timeline score: 1 | |
| Jan 13, 2015 at 1:11 | history | edited | dockeryZ | CC BY-SA 3.0 |
added 54 characters in body
|
| Jan 13, 2015 at 1:04 | history | edited | dockeryZ | CC BY-SA 3.0 |
edited title
|
| Jan 13, 2015 at 0:58 | history | edited | dockeryZ | CC BY-SA 3.0 |
edited title
|
| Jan 13, 2015 at 0:54 | comment | added | dockeryZ | See pictures added. | |
| Jan 13, 2015 at 0:52 | history | edited | dockeryZ | CC BY-SA 3.0 |
added 665 characters in body
|
| Jan 13, 2015 at 0:30 | comment | added | TheJamaicanGuy | You should double check the connections to ensure your LED is connected the right way around (long leg is positive) with a resistor to limit the current. Are you able to attach a picture of your setup? | |
| Jan 13, 2015 at 0:29 | review | First posts | |||
| Jan 13, 2015 at 5:54 | |||||
| Jan 13, 2015 at 0:24 | history | asked | dockeryZ | CC BY-SA 3.0 |