2

I am using RPi2 Model B with Raspbian Jessie.

I have connected an ESP8266 to Pi. Google says that I have to disable kernel debug messages and serial console login to use the serial port of RPi. I have disabled the kernel from using the serial port. Now no debug messages appear while powering on the Pi.

Following this link i have done 

sudo systemctl stop [email protected]
sudo systemctl disable [email protected]

to disable serial console login.

But when I try to communicate to ESP8266 using AT commands through minicom, I get a screen filled with "ERROR" and sometimes "Login Incorrect" and "5 Incorrect login attempts" (The error wordings are not exact)

How to rectify this? Any help is much appreciated.

Improve this question
1
  • I've edited the last paragraph out of your question since it invites general discussion about usage of the ESP8266, and we actually are not a discussion forum, we're a Q&A site; sometimes new users find this confusing. You should take the tour for further explanation, it is about 2-3 minutes.
    – goldilocks ♦
    Commented Jul 12, 2016 at 12:05

1 Answer 1

Reset to default
1

Following this link i have done

That link is outdated. To disable the serial console and login on current versions of Raspbian, all you have to do is edit /boot/cmdline.txt and remove:

console=serial0,115200

It may read ttyAMA0 instead of serial0, but the way to identify an entry for a serial console is the baud rate (115200) after a comma. Do not remove the other console entry, which should be console=tty1.

The current init system will automatically start a login on any serial console used by the kernel, so if you disable that, nothing further has to be done.

Beware that file (cmdline.txt) must remain all one line. You will need to reboot after editing it.

Improve this answer
3
  • I made a clean install of Raspbian Jessie and I did what you mentioned. If I send an AT command nothing is returned. Do you have any links which tells how to use ESP8266 with RPi 2 With Jessie?
    – Jitin Kodian
    Commented Jul 12, 2016 at 10:02
  • No, I've never used one; I left another comment on your question about this. The basic idea is to ask one focused question at a time. An advantage of this is, e.g., if you had asked something more opened ended and far ranging, I would not have bothered to answer (because I've never used an ESP8266) -- and perhaps no one else would have either, because it then becomes more esoteric. As is, it sounds like this at least solved your initial problem with the login console on the serial line.
    – goldilocks ♦
    Commented Jul 12, 2016 at 12:09
  • So: Now you are over that hurdle, please feel free to ask a separate question focused on use of the ESP8266! The more details you can include about 1) What you've actually tried, 2) What you expected to happen, and 3) What actually happened, the better your chances of getting decent advice.
    – goldilocks ♦
    Commented Jul 12, 2016 at 12:11

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.